Select the lathe and the control system
Confirm the lathe model and control designation on the machine. The CE adapter has specific L12 and L20E profiles. Configure the machine address, NC number and system number so readings come from the intended control and machining system.
The profile covers machine and run status, active program, alarm status and details, current tool, spindle speed, feed rate and time counters. The adapter reads these signals through the control’s CE interface. Its scope is monitoring. Program transfer and changes to tool offsets require other facilities.
Compare readings with the operator panel
Use an approved test cycle and compare the displayed program, tool and machine state with the local Edge readings. The default mapping translates the running state to producing. Check this against the machine’s actual behaviour, particularly on machines with more than one machining system.
A simulator can exercise the read path and mapping before a site visit. Commissioning on the physical machine is still needed to establish that the selected profile and signal meanings match the particular control.