Skip to content

Example scenario

Is dimensional drift related to tool wear?

Tool wear is worth investigating when the diameter rises with cutting time and returns toward target after successive insert changes.

A turned diameter is approaching its upper limit

A turned diameter with a target of 3.25 mm still passes inspection. The last few readings are higher than the first ones taken after the insert was changed.

How it works

  1. In Quality, open the characteristic and inspect the individual values and moving ranges. Note when the diameter began to move and whether the same limits applied throughout.
  2. In Tool Manager, open the machine position that holds the insert. Compare its offset history with the measurement times and the shop's insert change log.
  3. Repeat the comparison for the next insert. If Factory Director shows a recommendation about the tool, check its cited evidence against the readings.

How to interpret the result

Look for other changes at the point where the readings turn. If a new material lot or an offset adjustment coincided with the insert change, compare another run where only the insert changed.

Book a call about your factory

Tell us what you make and which machines you run, and we will walk through how Qynetic fits. If you would rather get news and early access, join the waitlist.